Hazet 4902/6, Operating Manual

Page: 14 / 40

14
4
7
6
8
5
1
3 Design and Function
• Insert bottom tensioning jaw
5
from the side
into the coil spring
(figure 1
).
• Push spindle, thrust piece and drive from
below through the suspension arm and the
spring upwards until reaching the bottom the
tensioning jaw.
• Push upper tensioning jaw
4
onto the
spindle (figure 2 ).
• Lower the splindle’s
1
6-point cap (calotte)
from the top downwards into the reception
hole of the upper tensioning jaw
(figure 3
).
• Check correct fit and assembly of the 6-
point cap (calotte) (figure 3 ).
• Pretension the system and check the spring’s
tight fit all around the internal guidance
(figure 4 ).
• Operate drive with the tubular box-end
wrench
6
and the reversible ratchet 8
(figure 5
).
• When removing the spring from the fixing
device/rubber protectors, retain with tubular
box-end wrench
7
in order to avoid turning/
twisting of the tensioning jaw.
fig. 1
fig. 2
fig. 3
fig. 4
fig. 5