REV2-6
TLC Series
haywardflowcontrol.com
4. DEVICE INSTALLATION
4.1. UNPACKING
The unit has been designed and manufactured in a way assuring a high level of user safety and resistance
to interference occurring in a typical industrial environment. In order to take full advantage of these
characteristics installation of the unit must be conducted correctly and according to the local regulations.
After removing the unit from the protective packaging, check for transportation damage. Any
transportation damage must be immediately reported to the carrier. Also, write down the unit serial number
located on the housing and report the damage to the manufacturer.
4.2. ASSEMBLY
Read the basic safety requirements on page 3 prior to starting the installation.
Ensure that the power supply network voltage corresponds to the nominal voltage stated on the unit's
identification label.
The load must correspond to the requirements listed in the technical data.
All installation works must be conducted with a disconnected power supply.
Protecting the power supply connections against unauthorized persons must be taken into consideration.
To install device on the wall, pinholes
should be made. Figure 4.1 presents
d i m e n s i o n s o f t h e d e v i c e a n d
distances between holes. The back
side of the device has four mounting
holes. This part of the case should be
mounted to a wall by screws.
Disconnect the power supply prior to starting assembly.
Check the connections are wired correctly prior to switching the unit on.
67 mm
110 mm
90 mm
60 mm
80 mm
4.4
o
8.4
o
Figure 4.1. Device and assembly dimensions
