REV2-16
TLC Series
haywardflowcontrol.com
7.2. PARAMETERS EDITION
7.2.1. Numeric parameters (digit change mode)
7.2.2. Numeric parameters (slide change mode)
7.2.3. Switch parameters (“LIST” type)
To start edition of any parameter, user should select name of desired one using [^] [v] buttons and then press
[ENTER].
In “slide change” mode ("Edit”=”Slid”), buttons [^] and [v] has different functions. To increase edited value press (or
press and hold) [^] button only, the increasing becomes faster as long as button [^] is pressed. To slow down the
button [v] can be used. If [v] is pressed shortly (and button [^] is still pressed), increasing will slow down for a moment
only, if [v] is pressed and held while button [^] is still pressed the quick digit change will be kept on lower speed.
To decrease edited value press (or press and hold ) [v] button only. The decreasing becomes faster as long as button
[v] is pressed. To slow down the decrease, button [^] can be used. If [^] is pressed shortly (and button [v] is still
pressed), decreasing slow down for a moment only, if [^] is pressed and held while button [v] is still pressed the Speed
will slow down and will be kept on lower speed.
Press [ENTER] at least 2 seconds to accept the changes, after that question ”Set?” is displayed, the user must confirm
(or cancel) the changes. To confirm the changes (and store them in EEPROM) press the [ENTER] button shortly after
”SEt?” is displayed. To cancel the changes press [ESC] button shortly after ”SEt?” is displayed. After that device returns
to the menu.
Numerical parameters are displayed as decimal numbers. The mode of the new value entered depends on chosen edit
method ( see parameter "Edit”).
In mode “by digit” ("Edit”=”dig”) pressing one of the keys [^] or [v] causes change of current position (flashing digit) or
the sign (+/-). Short pressing of the [ENTER] button causes change of the position (digit).
Press [ENTER] for at least 2 seconds to accept the changes, after that question ”SEt?” is displayed, and user must
confirm (or cancel) the changes. To confirm changes (and store it in EEPROM) press [ENTER] button shortly after ”SEt?”
is displayed. To cancel the changes press [ESC] button shortly after ”SEt?” is displayed. After that device returns to the
menu.
Switch parameters can be described as a set of values (a list) out of which only one of the options available on the list
can be selected for the given parameter. Options of switching parameter are selected using [^], [v] keys. Short (Quick)
pressing of [ENTER] results in the display the user to acknowledge the question (”SEt?”). If key [ENTER] is pressed
again, the changes are accepted, stored in EEPROM end the edition process finished. Pressing the key [ESC] after ”SEt?”
causes cancelling of changes made and display returns to the main menu.
While editing numeric parameter:
• Change of current (flashing) digit
• Slide change of value (acceleration, deceleration, direction change)
While editing switch parameter - selection of switch parameter.
Functions of buttons when editing numeric and switching parameters:
