USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
3
at the transformer while the light is “on” and operating in “white” mode. In some cases, a voltage
greater than 12 volts is required due to a long cord run. Some transformers provide higher voltage
taps for this purpose; check your transformer manufacturer’s installation instructions for details.
When using Hayward or other transformers that offer a 14v option, we suggest that you always use
the 14 volt tap.
Installation Overview
Refer to the diagram below of an overview of the ColorLogic/CrystaLogic 1.5” LED light installation.
Be sure to read all of the following sections before installation.
Installation Location
When installed in water, the ColorLogic or CrystaLogic 1.5” LED light must be installed in a wall or
on a floor of the pool or spa with the top of the lens not less than 4 inches (10 cm) below the normal
water level of the pool except when the fixture is installed in an area of the swimming pool that is not
used for swimming. Select a location for the light fixture(s) that will give optimum light dispersion for
the pool or spa design. Be sure to consider the direction of emitted light and take care not to point
lights directly at the house or outdoor living spaces.
Product
Total Cord Length
from Transformer
to Light
12v
Accent Light
Minimum Required
Voltage at
Transformer
30 ft
50 ft
100 ft - 150 ft
12 - 14 volts
13 - 14 volts
14 volts
Pool wall surface
4” min.
(top of lens)
4” min.
9” min.
11” min.
8” min.
Water line
to
12 VAC
Transformer
48” min.
1.5” PVC Conduit
1”Conduit
INSIDE POOL
use Hayward SP0536,
SP0537, SP0538 wall fittings
for LYWUS11xxx, LAWUS11xxx, LACUS11xxx & LYCUS11xxx models
for LACUN11xxx & LYCUN11xxx models
long sweep only
