10/08
Model H1001.8/H1001.8HPS
Page 4 of 7
INSTALLATION PROCEDURE…
Step 8
:
Thoroughly flush supply line to remove all foreign matter. Connect 1/2” IPS
supply screwdriver stop (not supplied) to stub-out in wall. Place chiller on chiller
support tray against right hand side, fully to rear, with condenser (open panel)
side facing to front. Install supply, 3/8” O.D. tubing (not supplied), between
screwdriver stop (not supplied) and strainer at chiller inlet. (Cut tubing to proper
length, and follow general notes for proper connection procedure for push-in style
fittings). Tubing insulation is not normally required on inlet side of chiller. Install
insulated tube (supplied) between fountain and chiller outlet. Cut tubes as
required and connect to chiller outlet compression fitting. Open screwdriver stop
wide open while checking for leaks at all connections. Also check waste for
leaks.
Step 9
:
Adjust bubbler stream height using a small flat-head screwdriver inserted through
a hole in the center of the push button. For increased flow turn clockwise and for
decreased flow turn counterclockwise. If flow problems arise, see
troubleshooting guide for additional instructions to correct problems. Bubbler
stream may lower during short break-in period. Set initial stream height a little
high to minimize or eliminate the need for break-in period readjustment.
Step 10:
Verify that electrical power is off and power supply voltage, phase and cycle
match specifications printed on chiller label. In accordance with local codes, wire
directly to incoming lines at internal chiller junction box. Verify that all inner
packing is removed and hand rotate fan blade to verify free rotation. Reattach
chiller front panel. Turn power on and verify that chiller cycles off after water
reaches proper temperature. Finally check for leaks.
Step 11:
Install grille and tighten outer side screws. Verify there is chilled water out of
bubbler.
FIGURE 1