Wheel Alignment AXIS500
AXIS500 Manual Instructions
9
3.3
Description
The electronic inclinometer is used to record angle values on the vehicle geometry.
This device enables the camber, caster and included angle to be determined.
Angles can be measured in the horizontal and vertical plane depending on the attachment
face.
Display symbols:
Camber display
Request for value recording
Caster / KPI
Angle value display:
Upper line: Caster
Lower line: KPI
3.4
Button assignment
ON/
OFF
On / Off button
Light
Switch on background lighting for 30 seconds.
Switches between the
camber measurements, caster / KPI
and max. steering
.
The first mode is the
camber measurement, where the result of the angle is directly shown. In caster / KPI mode, LED's light
signals confirm the recorded
angle changes and after the procedure has ended the display automatically
switches to the display values for
caster
(upper line) and
KPI
(lower line).The third mode is for calculating
the max. steering angle. Press the button again to switch back to the camber display.
Tara
Press this button to adjust the angle measurement to an inclined plane. The angles in both measuring
directions are thus adjusted to zero. This operating state is indicated by a symbol in the bottom right-hand
corner. Press this button again to switch back to display of the absolute angle.
Hold/
Save
Press this button to "freeze" the angles in the display. This operating state is indicated by a symbol in the
bottom left-hand corner. If the button is pressed again the display switches back to continuous display of
the measured values.
On / Off switch
Display lighting
For angle
measurement in an
inclined plane.
Illuminated LC display
Switches between the
angle measurements
Keep angle values in
the display
LED indicator light
Summary of Contents for AXIS 500
Page 2: ......
Page 49: ...Wheel Alignment AXIS500 AXIS500 Manual Instructions 47 Annex 13 4 Measurement report...
Page 51: ......
