713686 rev 6
6
IRT 3-1 PcD, IRT 3-2 PcD and IRT 3-20 PcD
8. Settings
Mode
8.1 Log
In
To enter the settings mode you fi rst have to ”log in”. Press
both
arrow keys
as you turn the main switch on. The
display will ask you for a PIN code.
8.2 PIN
code
Use the arrow keys to fi ll in the correct digit. Press
enter
to
confi rm and edit the second, third, and fourth digit of the
code.
No code is required for basic settings, just press OK for the
default code of 0000. To change this code, read chapter
“8.4.6 Basic PIN Code”.
Advanced PIN code
5780
Used for program adjustments and advanced settings.
To change this code, read chapter 8.4.13 “Advanced Pin
Code”.
Attention!
an entered PIN code is valid globally in the
software until the main switch is turned off, i.e. if you enter
advanced settings mode and then exit to program mode.
The program editing will still be editable until the main
power is turned off.
8.3 Navigation
To adjust a setting, press
edit
. To go back from edit mode to
settings mode without saving, press
cancel
.
Note!
If you press exit from settings mode you will be re-
directed to “program mode”. You will then need to repeat
from step “8.1 Log In” to enter “8.4 Settings” again.
8.4 Settings
8.4.1
1 Select Language
Use the up and down
arrow keys
to scroll through the four-
teen different languages (arranged alphabetically) until the
correct language appears. Press
select
to confi rm.
If you accidently switch to a language that you don´t under-
stand, turn the main switch on while pressing the “cassette
in use” button. The dryer will then start up with British
English.
8.4.2
2 Power Mode
The dryer is supplied from factory with “low” temperature
settings for new users, this means that the pre-installed
programmes are set moderately. If you´re already familiar
with the high-performance IRT dryer, choose ”high” for an
increased drying performance.
Note!
The program settings that you changed/added in
program mode is only available in the low or high program
mode where they were changed/added.
Ch.
Overview Basic Advanced
8.4.1
1 Select Language
x
8.4.2
2 Power Mode
x
8.4.3
3 Process Alarm
x
8.4.4
4 Temp Unit
x
8.4.5
5 Buzzer
x
x
8.4.6
7 Basic PIN Code
x
8.4.7
8 Short Dist lim.
x
8.4.8
9 Long Dist lim.
x
8.4.9
15 Temperature Ctrl
x
8.4.10 16 Disp. Contrast
x
x
8.4.11 23 Filter Time
x
8.4.12 25 Contin. Mode
x
8.4.13 36 Advanced PIN Code
x
8.4.14 37 Dist Unit
x
8.4.15 43 Advanced Code
x
8.4.16 44 Reset Prog. Settings
x
8.4.17 45 Reset Filter Timer
x
8.4.18 46 Statistics
x
x
8.4.19 47 Perform Self test
x
x
available in
Use
arrow keys
to change
language and
select
to
confi rm.
Use the
arrow keys
to
scroll through the set-
tings, see table in chapter
8.4.
Press exit and you
will be directed to
“program mode”.
edit mode
