- 28 -
- 29 -
EN
EN
Installation/Operation/Disassembly
06 Installation/Operation/Disassembly
Figure 6-16
Figure 6-17
(Optional) Install an undewater camera: Connect the mount adapter to the mounting hole, and attach the
camera to the adapter. (Figure 6-17)
By pressing down the left wing switch, the power display and
green light will be on. Single click the right wing switch to shift
the speed levels.
Steps 11
Steps 10
NOTE:
Press and hold the left wing power switch, and the LED
indicator and also the green light will be on. Press and hold the right
wing speed switch, if the propellers start spinning, it works normally.
You need to recharge it before use.
Once the unit has been fully assembled and the procedures have been followed, please remember to always maintain
a safe distance from other swimmers, marine craft and other dangers as described in this manual. Please make sure
not to stay too far away from your companion at any time.
Now you're ready to go!
Steps for Operation
Installation/Operation/Disassembly
06 Installation/Operation/Disassembly
1.
Enter the water with the Aquajet Dive H2. Place the H2 flat in the water, allowing it to float.
2.
With the head cover pointed away from you, place your arms through the wrist straps, effectively reaching forward of
the wings. See pages 21 and 28 for more information.
3.
In order to activate the display screen and power the unit, gently hold down the left switch and observe the display
screen as it cycles through the current battery power: Note, for the best results, please ensure your battery power is
above 90%.
4.
Once you have got sufficient power for the battery, you're ready to take off with your Aquajet Dive H2. Initiate the
power with the right wing speed switch. By pressing this switch, you will notice a small 'click' between each 'gear' - this
is a 3 gear/speed system. So as you continue to press the speed button, your gears will continuously cycle through
1st, 2nd and 3rd gear. Note: In order to keep the device powered you must maintain continuous pressure on the left
switch, thereby creating a two handed operation.
5.
You may power off the device at any time by releasing the left switch. Note this will reset your current gearing to the
1st gear in the cycle if you reinitiate the use.
action sports camera mount
switch
speed
Figure 6-18