KK-K9-D22-K_INST_9-07
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
TIPS FOR INSTALLATION:
•
Cordless drill with Phillips screw bit is recommended to help speed up installation time.
•
Rear and ceiling fillers as well as step sill may require you to apply pressure when attaching
them to the cage. This will aid in achieving a clean tight fit and may require two installers during
these steps.
•
PVC protective covering should be removed during installation. Peeling it back while attaching
hardware.
SUB ASSEMBLIES:
1. Remove necessary interior trim parts:
•
Remove rear seat
•
Remove OEM door panels.
Note: if the door has an electric lock system and/or
window controls, the switches must be reconnected.
The switch assembly must be wire tied to inner door
panel and placed inside a plastic bag so, as not to
interfere with the window or lock mechanisms.
•
Remove OEM door lock pin assembly
•
Remove OEM step sill panel
•
Remove seat belts – remove inboard belt latch and buckle (center of car)
2.
Loosely attach rear-mounting foot to vehicle using factory seat hardware on floor of vehicle.
Note: DO NOT tighten these bolts until Step 6 of the installation process.
INSTALLATION:
1. Place Floor:
Remove OEM
door rod
Rear of vehicle
Summary of Contents for KK-K9-D22-K
Page 4: ......
