USER MANUAL
8
install.havenlock.com
Need to access the manual online?
If needed, the online installation manual will also walk you through the many different install scenarios you might encounter.
Drill Holes into Floor
3.1
Take a power drill with a 1/8" drill bit and drill pilot
holes
2 inches down in at least 4 of the 6 holes
ensuring
that there are more screws attachment points on the
side closest to the doorknob for strength.
3
Remove Locking Gate Cover
4.1
When ready to mount and install the HAVEN Connect Z,
remove the HAVEN locking gate cover by removing the 4
small screws (Phillips head screwdriver) on the back of the
locking gate.
Line up Haven with your pilot holes. Make sure the locking
gate is down. If you determined you needed a riser place
that down first - then place the lock on top of the riser(s).
4
Secure Haven to Floor
5.1
Firmly secure Haven to the floor using the 4-6 install
screws.
DO NOT over tighten the screws.
It may cause
damage to the internal mechanisms in the unit.
5.2
Replace the locking gate cover while locking gate is up.
Installation is complete!
5
