Setting Up the Fence Boundar
y/T
rigger Zone
Setting Up the Fence Boundar
y/T
rigger Zone
5
www.HavahartWireless.com
6
1-800-800-1819, OPTION 453
Setting Up the Fence Boundary/Trigger Zone
2
Setting Up the Fence Boundary/Trigger Zone
2
Screen 2.0
Screen 2.1
Placing Fence Boundary Training Flags :
(see Illustration C)
NOTE: These flags represent the desired location of your Wireless Fence Boundary. Be
sure that the flags form an enclosed area and that your house is inside the Boundary.
Objects that attenuate the signal might pull the Fence Boundary in from where the flag
line was placed. This is normal with Wireless Fences.
Illustration C
Screen 2.4
Screen 2.3
Screen 2.2
Recording the Fence Boundary/Trigger Zone:
•
Start at a blue flag, press “Record” (see Screen 2.2), wait 10 seconds, then walk at a slow
deliberate pace while holding the Controller over the flags. Don’t allow your body to
block the communication between the Controller and Bases while recording your Fence.
•
Slow down when walking around corners. Stop for 1 second at each corner if you want
the system to make a sharp corner point. When you return to the starting flag press
“Done” (see Screen 2.3).
•
A congratulatory screen will appear. Press “Next” (see Screen 2.4).
•
When selecting the location of your Fence Boundary, always keep in mind the 6 -13 foot
Trigger Zone that will surround your Boundary. Also be sure to plan your Fence Boundary
at least 6
1/2
feet from a roadway.
- Place the blue Boundary flags in the ground to establish the desired perimeter of
your Boundary.
•
Once the flags have been placed in the ground, press “Next”
on the Controller (see Screen 2.0). The System will locate the Controller (see Screen 2.1).
Select one blue Flag as your starting point.
NOTE: For more information on Exclusion Zones, please see our Instruction Manual:
www.havahartwireless.com/resource/uploads/custom-select-instruction-manual.pdf
