Hauslane Auto-clean Series Instruction, Use & Care Manual Download Page 7

Step 6 - Electrical Connection 

� 

WARNING 

Risk of electrical shock. Electrical wiring must be done by qualified personnel in accord­

ance with all applicable codes and standards. Before connecting wires, switch power off at 

service panel and lock service disconnection means to prevent power from being switched 

on accidentally. 

1. Connect cable to range hood wiring using 

wire connectors. Connect BLACK to BLACK, 

WHITE to WHITE, GREEN or BARE wire to 

GREEN wire. 

2. Reinstall wiring box cover. 

3. Plug back the small white connector 

(attached with the bottom panel) inside the 

hood. 

4. Reinstall bottom panel. Make 

sure both grease guides are aligned 

with the holes. 

5. Using long nose pliers, pull out 

the end of each grease guides (A).

Then, set them in such a way their

slightly protrudes above the 

bottom panel surface (B). 

6. Install the long grease cup at the 

end of the hood bottom. 

7. Install the two small round 

grease guard cups onto the two 

metal guard. Push in and turn

clockwise.

Page: 12 

Model: C190 Standard Series 

A. Power Off Switch

B. Low Speed  Switch

C.

Middle Speed Switch

D.

High Speed  Switch

E.

Light  Switch

??

----------+-

r�r 

rr r ---------------

131

E  D  C  B A

Model: C395  Premium Auto-clean Series 

A. Auto-Clean Switch-

press once will go into the 38 seconds auto-clean mode. It

will starts to spray the degreaser that stored at the water tank and clean up the fans,

then automatically stop in 38 seconds.

B. Low Speed  Switch (6 speed step down)

C. High Speed  Switch (6 speed step up)

D. Power On/off Switch

E. Light  Switch

t?.7P 

CD  E 

Install/ Replace of the Light Bulb 

Light bulb is included in this package. For future replacement, this is a

110/120V, 40W A-15 type incandescent lamp (available at most

hardware stores). We highly recommend using a 3.5W LED light bulb.

WARNING -  If you use a bulb over 40W, it will seriously caused damage to the 

hood and the warranty will be voided! 

Install of a light bulb 

1) Turn off the power of the range hood

2) Unscrew the light diffuser retaining screw.

3) Rotate the 40W A-15 type incandescent lamp clockwise into the socket holder

Page: 13 

Hauslane

267 Wattis Way, San Francisco, CA 94124 
Tel: 1-800-929-0168 E-mail: [email protected] 

Hauslane

267 Wattis Way, San Francisco, CA 94124 
Tel: 1-800-929-0168 E-mail: [email protected] 

Summary of Contents for Auto-clean Series










Reviews: