Haulotte COMPACT 10, Maintenance Book

Page: 92 / 118

92 4001012670 E 06.20 USA / GB
Compact 8 (C 2032E) - Compact 8W (C 2047E) - Compact 10 (C 2747E) - Compact 10N
(C 2632E) - Compact 10N-1 - Compact 12 (C 3347E) - Compact 14 (C 3947E)
E -
Trouble shooting and diagram
AL75 4
The general contactor driver does not close
(Contactor coil problem)
Check the relay coil SB1 (Faulty coil)
The general contactor driver does not close
(Variable speed drive problem)
Check the relay coil SB1 (Coil is operational)
AL78 2
Accelerator is high in idle mode (Faulty
joystick). Check the potentiometer powered in
51 / 52, output at 39
Check the joystick SM1. .
Accelerator is high in idle mode (Faulty
joystick). Check the potentiometer powered in
51 / 52, output at 39
Check the voltage between wires 51 and 52
(potentiometer setpoint)Faulty serial card
AL79 2
Erroneous start-up sequence (Joystick
connection)
Check the joystick SM1. Faulty joystick.
AL80 2
Double operation request (serial card or
joystick)
Check the joystick SM1. Faulty joystick.
AL90 4
YV6 coil faulty or not properly connected
(wires 25/7, theoretical resistance: 75 Ohms)
Check coil YV6
YV6 coil faulty or not properly connected
(inversion of wires 5 and 27 on terminals 18
and 18)
AL91 2
The version (standard or Europe) is not
correct. The 2 VERSION and OK FOR
VERSION parameters are different
Adjustment problem (console). Console
programming.
AL93
Drivers 2KO SIC Problem with small wiring
harness between MDI and the ground control
box. Check the short-circuit between the ground
control box earth and the SA2 switch in the
control box
AL94 6
The control PC does not respond correctly to
the SIEMENS PC (faulty variable speed
drive)If the horn is weak, change the coil's
general contactor at CC
Change the variable speed drive
AL95 7 Pressure switch alarm
Weighing card overload (cable 28 at 0V)Input
voltage at J4.6 = 0V
Faulty weighing card
AL96 7 The platform is at maximum height
SQ3 contactor contact switch open (Normal if
the platform is actually at maximum height)
AL97 5
Maximum current during braking or if the
platform is in drive mode
High-level current at the input coming from the
pump (check the pressure and the pump for
current and isolation). Check the brakes
AL98 0
Difference between the variable speed drive
and MDI engine hour meters
Faulty chassis emergency stop auxiliary
contact switch
Difference between the variable speed drive
hours and the MDI hoursCheck the engine
hour meter
Difference between the variable speed drive
hours and the MDI hoursChange the variable
speed drive
AL99 6 Request for programmed maintenance
Alarm codes Nb. of flashes Causes Solutions