Haug 04.7614.000, Operating Instructions Manual

Page: 12 / 24

5 Installation
ATTENTION!
The shielding and insulation of the cable
may be damaged if the cable is kinked or
bent. This will result in a short-circuit.
•
The high-voltage cable must not be
kinked.
•
When routing around bends, the
bending radius must not be smaller
than 50 mm.
4. Switch off power pack and secure
against inadvertent operation.
5. Insert the ionizing unit’s high-
voltage plug in the high-voltage
socket of the power pack and press
the high-voltage cable until it
reaches the stop.
6. Screw the screw cap onto the high-
voltage socket and tighten by hand.
12