HATO 535Y, Operating Manual

Page: 20 / 27

closing time and when the warning signal is on, it blinks 3 seconds before starting the
movement.
ATTENTION! When the motion signaling function is switched off, the function of signaling
full opening is active. When the motion signaling is on, the signal of full opening is
disabled.
SIGNALING OF BARRIER MOVEMENT
Hold down the SETUP button.
The LED will turn on and then turn off.
Release the SETUP button.
The LED will blink rapidly for 2s.
After the flashing is finished, the LED will
show the status of the function. The lighted
on means active function, and off the
function inactive.
turned on
disabled
To change the state of the function to the
opposite, press the SETUP button briefly
within 3 seconds.
After 3s from the last press, the LED will
flash 3 times. The controller will remember
the settings and return to normal operation.
WARNING SIGNALS
The warning signal function consists in flashing the lamp for 3 seconds before activating the
barrier in the opening or closing direction.
Hold down the SETUP button.
The LED will turn on, then turn off and on
again.
Release the SETUP button.
The LED will blink rapidly for 2s.
After blinking, the LED will show the current
status of the function. The lighted on means
active function, and off the function inactive.
turned on
disabled
To change the state of the function to the
opposite, press the SETUP button briefly
within 3 seconds.
After 3s from the last press, the LED will
flash 3 times. The controller will remember
the settings and return to normal operation.