10
Form No. TQCEM-1002
MAINTENANCE
4. Remove the right-hand chrome snap plug to gain access
to the motor bearing. See 5 .
5. Lubricate the bearing by applying 10-12 drops of Mobil
SHC 624 lubricant (Hatco part no. 05.01.018.00) to the bearing
through the access hole. See 10 . Re-install the chrome plug.
6. Re-install the toast ramp. Make sure ramp is securely
positioned over front and rear support pins.
7. Move discharge vane to desired position.
Motor Bearing Lubrication Schedule
24 hours operation . . . . . . . . . . . . . . . . . . . . . . . . .Every 6 weeks
18 hour operation . . . . . . . . . . . . . . . . . . . . . . . . .Every 8 weeks
12 hour operation . . . . . . . . . . . . . . . . . . . . . . . .Every 12 weeks
Periodic operation . . . . . . . . . . . . . . . . . . . . . . . .Every 6 months
WARNING
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service Department
at 800-558-0607 or 414-671-6350; fax 800-690-2966 or
International fax 414-671-3976.
WARNING
This product has no “user” serviceable parts. To avoid
damage to the unit or injury to personnel, use only Authorized
Hatco Service Agents and Genuine Hatco Parts when service
is required.
WARNING
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely in
Hatco equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure to use Hatco
Replacement Parts may subject operators of the equipment
to hazardous electrical voltage, resulting in electrical
shock or burn.
!
!
!
ACCESSORIES
ADJUSTABLE LEGS
1. Carefully place unit on its side.
2. Remove the existing legs.
3. Thread the 10 cm (4") adjustable legs into the existing leg
holes on the bottom of the unit. See 11A and 11B .
4. After all legs are secure, return the unit to the upright position.
5. If unit is not level, use a 14 mm (9/16") open-end wrench
to adjust the foot of each leg until unit is level.
STACKING HARDWARE KIT
1. Remove crumb tray and toast tray from units.
2. Remove the side cover screws from the rear of the lower unit.
3. Tip the unit forward and remove rear legs.
4. Attach the stacking brackets to the unit with the original screws
and re-install rear legs. Right side bracket has a notch cut out
for the power cord. See 12 .
5. Set the unit upright.
6. tip the upper unit forward and remove the back legs. Place
upper unit onto lower unit, aligning the leg mounting holes
with the holes in the stacking brackets.
7. Re-install rear legs through bracket holes into upper unit
and remove front legs on upper toaster.
8. Re-install crumb tray and toast collector pan into unit.
NOTE:
The “Stacking Hardware Kit” is for NON-CE units only.
ELECTRICAL RECEPTACLES
Various electrical receptacles are available for different applications.
See the applicable
ELECTRICAL RATING CHART
for details.
Summary of Contents for TOAST-QWIK TQ-300
Page 53: ...Form No TQCEM 1002 52 NOTES ...
Page 54: ...Form No TQCEM 1002 53 NOTES ...
Page 55: ...Form No TQCEM 1002 54 NOTES ...
