PROGRAMMING CONTROLLER
8
Form No. TFC461RM-0108
8. Both upper and lower heat indicators glow. The display
shows
(the time value for how long conveyor
remains stopped). Repeatedly press Up
or Down
arrow key to scroll to desired setting. Holding down an
arrow key will cause the numbers to change rapidly. Time
can be adjusted from zero to 9 minutes 59 seconds.
9. Press the Enter
key to proceed to the next step.
10.Press the program selection key selected in Step 1 to save
all the settings into memory. The display will show
.
NOTE: In the Continuous Run mode, the conveyor advances
in 1/2 second increments.
When the unit reaches
mode, the upper heating elements automatically go
into a programmed idle power setting. (The display will still show
during idle
mode.) The unit remains in IDLE mode until one of the ten program selection keys
are pressed or the unit goes into AUTO-OFF Mode.
NOTE: Begin with an IDLE mode setting of 30% and adjust the program accordingly
to achieve optimum performance.
1. Simultaneously press/hold the Up
arrow key and the Enter
key for
three
seconds
. The display will show the current programmed power value.
2. Repeatedly press Up
or Down
arrow key to
scroll to desired setting. Setting will change by
10% every time a key is pressed.
3. Press the Enter
key to save setting.
5. The lower heat indicator glows and the display reads
(Lower Power Value).
6. Repeatedly press Up
or Down
arrow key to scroll to
desired setting.
7. Press the Enter
key to proceed to the next step.
1. With display showing
, simultaneously press/hold
program selection key (9 or 10) and Enter
key for five
seconds.
2. After 3 seconds, the upper heat indicator glows and the unit
displays
(Upper Power Value).
3. Repeatedly press Up
or Down
arrow key to scroll to
desired setting.
4. Press the Enter
key to proceed to the next step.
KEYS 9 AND 10 (CYCLES CONTINUOUSLY WHEN PRESSED)
IDLE MODE
Summary of Contents for THERMO-FINISHER TFC-461R
Page 19: ...NOTES Form No TFC461RM 0108 17...
