Form No. TF1946M-1004
13
MAINTENANCE
GENERAL
The Hatco Thermo-Finisher™ warmers are
designed for maximum durability and performance
with minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any maintenance.
NOTE: When the unit is HOT the blower fans will
remain on even when the power switch is turned off.
CLEANING - EXTERIOR
To preserve the bright finish of the unit, it is
recommended that the exterior surfaces be wiped
daily with a damp cloth. Stubborn stains may be
removed with a good stainless steel cleaner or a
non-abrasive cleaner.
CAUTION
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your
Thermo-Finisher, marring its appearance and
making it susceptible to dirt accumulation.
BLOWER MOTORS
Inspect rear blower motors for food and/or grease
build up and clean off if necessary.
CLEANING - INTERIOR
WIRE PLATE RACK
Remove rack from unit and wash with a mild soap
and water solution and rinse.
GLASS SURFACES
WARNING
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any maintenance.
Upper and lower glass surfaces can be cleaned
after the unit has
cooled for at least one hour
.
With the wire plate rack removed carefully use a
“grill scraper” or other small hand held scraper and
scrape loose any food debris that has accumulated
on the glass.
CAUTION
Do not remove the glass from the unit for
cleaning purposes. Doing so may cause injury
or damage to the unit.
Remove any stains from the heating surfaces by
wiping off the glass using a moist cloth and ceramic
cooking top cleaner.
WARNING
Unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water. Do not steam clean the interior or flood
with water or liquid solution.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
WARNING
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Replacement Parts when service
is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
