Form No. HXmm-1215
11
MAINTENANCE
English
General
Hatco Heated merchandisers are designed for maximum
durability and performance with minimum maintenance.
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning, setup, or
maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not “jet-proof” construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no “user-serviceable” parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
Do not move or relocate unit for cleaning. Unit is bulky and
heavy.
Daily Cleaning
To maintain performance and preserve the finish of the Heated
merchandiser, clean the unit daily.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring
its appearance and making it susceptible to soil
accumulation.
IMPORTANT—DO NOT use paper towel or glass cleaner to
clean plastic surfaces such as sneeze guards and
flip-up doors. Paper towel and glass cleaner may scratch
the material. Wipe off plastic surfaces using a soft, clean,
water-dampened cloth.
WARNING
WARNING
CAUTION
NOTICE
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove and discard any remaining food product.
3. Swing open the glass side panels for easy access to the
entire shelf for cleaning.
NOTE: The glass side panels are held in place magnetically.
4. Remove and clean the product divider rods and channel
dividers.
• Lift the product divider rods straight up and out of the
channel dividers.
• The channel dividers are held in place by magnets
positioned along the front edge and back edge of the
shelf. To remove a channel divider, pull the divider away
from the edge.
Cleaning a Heated merchandiser
5. Wipe down all exterior and interior surfaces using a non-
abrasive, damp cloth (a non-abrasive cleaner may be used
for difficult stains).
6. Wipe dry all surfaces using a non-abrasive, dry cloth.
7. Clean the glass side panels using a standard glass cleaner.
8. If equipped, clean the plastic sneeze guards or flip-up
doors using soft cleaning cloths, mild soap, and water.
NOTICE
: Do not use paper towel or glass cleaner on
plastic surfaces—scratching may occur.
Channel Divider
Product
Divider Rod
Glass Side Panel
swung open.
