Top Heat Control
an optional top heat control is available for models GR2BW-24
through GR2BW-60. a top heat infinite control allows the
operator to manually adjust the upper heat output from full
wattage down to any desired level. a top heat control is not
retrofittable.
14" (356 mm) Sneeze Guards
Optional 14" (356 mm) sneeze guards are available for GR2BW
models instead of the standard 7-1/2" (191 mm) sneeze guards.
Side Panels
Clear plastic side panels are available as an option for all
GR2BW models. Use the following procedure to install each side
panel (see “Installing the Side Panels” Figure below). Side
Panels are not retrofittable.
1. Insert the top of the side panel into the upper bracket.
2. Slide the bottom of the side panel into the channel of the
lower bracket.
OPTIONS AND ACCESSORIES
14
Form No. GR2S2BWm-0511
4" (102 mm) Designer Legs
4" (102 mm)
Designer
legs are available as accessories for
GR2S and GR2BW models.
Designer
legs come standard on
models 42” or wider. To install the legs:
1. Carefully lay the unit upside down on cardboard.
2. Install the four legs. at each corner of the unit:
a. Line up the hole in the middle of the 3" (76 mm) leg
extension with the screw hole in the bottom of the unit.
b. Position the washer in the recessed area of the rubber
foot and place the rubber foot on top of the leg
extension.
c. make sure all are aligned and place a screw through the
washer/hole in the recessed side of the rubber foot,
through the leg extension, and into the hole in the bottom
of the unit. Tighten securely.
d. after all the legs are secure, return the unit to its upright
position.
Figure 10. Designer Leg Installation
Leg Extension
Washer
Screw
Rubber Foot
Screw Hole
Lower Bracket
Upper
Bracket
Side
Panel
Figure 11. Installing Side Panels
