INSTALLATION
4
Form No. QWM-0208
General
Read all safety messages in the IMPORTANT
SAFETY
INFORMATION
section
before
operating this equipment.
1. Plug the unit into a properly grounded electrical
outlet of the correct voltage, size, and plug
configuration. See the SPECIFICATIONS
section for details.
2. Move the power switch to the ON position (see
Figure 5). The switch will illuminate.
3. Allow the unit 15–20 minutes to reach operating
temperature.
4. Fill a separate, 1/6 size steam table pan or high
temperature amber pan with pre-heated food
product.
Do not put food product directly into unit. A
separate food product pan must be used. Failure
to use a separate pan may result in improper
cleaning and create an electric shock hazard.
Make sure food product has been heated to the
proper food-safe temperature before placing in
the unit. Failure to heat food product properly
may result in serious health risks. This unit is
for holding pre-heated food product only.
5. Place the filled product pan into the unit. For
best results, keep the product pan covered.
WARNING
WARNING
Figure 5. QW-6 Operating Controls
BURN HAZARD:
• Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
• Do not move or relocate unit while it contains
food product. Remove product pan and allow
unit to cool completely before moving or
cleaning.
Power Cord
Power Switch
OPERATION
General
The Que Warmer is shipped from the factory with
all components assembled and ready for use.
1. Remove the unit from the box.
2. Remove the information packet.
NOTE: To prevent delay in obtaining warranty
coverage, fill out and mail in the warranty
card to Hatco.
3. Remove tape and protective packaging from all
surfaces of unit.
FIRE HAZARD: Locate the unit a minimum of 1″
(25 mm) from combustible walls and materials. If
safe distances are not maintained, combustion
or discoloration could occur.
WARNING
4. Place the unit in the desired location.
• Make sure the unit is at the proper counter
height in an area convenient for use.
• Make sure the countertop is level and strong
enough to support the weight of the unit filled
with product.
• Make sure all the feet on the bottom of the
unit are positioned securely on the
countertop.
Summary of Contents for GLO-RAY QW-6 Series
Page 9: ...NOTES Form No QWM 0208 7...
Page 10: ...Form No QWM 0208 8 NOTES...
