IMPORTANT SAFETY INFORMATION
Form No. QWM-0208
1
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical
outlet of the correct voltage, size, and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine and install the proper voltage and
size electrical outlet.
• Turn the power switch OFF, unplug the power
cord, and allow the unit to cool before
performing any maintenance or cleaning.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if unit
has been submerged or saturated with water.
• Unit is not weatherproof. Locate the unit
indoors where the ambient air temperature is
a minimum of 70°F (21°C).
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or
worn.
• Do not attempt to repair or replace a
damaged power cord. The cord must be
replaced by Hatco, an Authorized Hatco
Service Agent, or a person with similar
qualifications.
• Do not use corrosive cleaning agents to
clean the unit. Corrosive cleaning agents
may eat through the unit, allowing liquids
into the housing.
• Use only Genuine Hatco Replacement Parts
when service is required. Failure to use
Genuine Hatco Replacement Parts may
subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco
Replacement Parts are specified to operate
safely in the environments in which they are
used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment.
WARNING
FIRE HAZARD: Locate the unit a minimum of 1″
(25 mm) from combustible walls and materials. If
safe distances are not maintained, combustion
or discoloration could occur.
Make sure food product has been heated to the
proper food-safe temperature before placing in
the unit. Failure to heat food product properly
may result in serious health risks. This unit is
for holding pre-heated food product only.
This unit has no “user-serviceable” parts. If
service is required on this unit, contact an
Authorized Hatco Service Agent or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
BURN HAZARD:
• Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
• Do not move or relocate unit while it contains
food product. Remove product pan and allow
unit to cool completely before moving or
cleaning.
Locate the unit at the proper counter height in
an area that is convenient for use. The location
should be level to prevent the unit or its
contents from falling accidentally and strong
enough to support the weight of the unit and its
contents.
Do not lay unit on the side with the control panel
or damage to the unit could occur.
Use non-abrasive cleaners only. Abrasive
cleaners could scratch the finish of the unit,
marring its appearance and making it
susceptible to soil accumulation.
WARNING
NOTICE
CAUTION
Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
Summary of Contents for GLO-RAY QW-6 Series
Page 9: ...NOTES Form No QWM 0208 7...
Page 10: ...Form No QWM 0208 8 NOTES...
