INSTALLATION
Form No. GRpWSm-0610
8
General
Hatco Glo-Ray
®
pizza Warmers are shipped with most
components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to the unit and
components enclosed.
ELECTRIC ShOCK hAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE hAzARD: Locate unit a minimum of 1″ (25 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
The National Sanitation Foundation (NSF) requires that
units over 36″ (914 mm) in width or weighing more than 80
lbs. (36 kg) either be sealed to or raised above the
installation surface. If unit cannot be sealed at the point of
use, 4″ (102 mm) legs are included to allow for proper
cleaning access below unit.
1. Remove the unit from the carton. Two people are required
for this step.
2. Remove the information packet.
NOTE: To prevent delay in obtaining warranty coverage, fill out
and mail in the warranty card to Hatco.
3. Remove tape and protective packaging from all surfaces of
unit.
Do not lay unit on the side with the control panel. Damage
to unit could occur.
4. Install the 1″ (25 mm) rubber feet or 4″ (102 mm)
adjustable legs. Two people are required for this step.
a. Carefully lay the unit on its side.
b. Install the feet or legs.
To install the 1″ (25 mm)
rubber feet:
• Thread a foot stud into the
hole at each corner on the
bottom of the unit. Tighten
securely.
• Slip a rubber foot over
each foot stud.
To install the 4″ (102 mm) adjustable legs:
• Thread a leg into the hole
at each corner on the
bottom of the unit. Hand-
tighten the legs until snug.
Do not over-tighten.
c. Return the unit to the upright
position.
NOTE: 4″ (102 mm) legs are
adjustable for leveling the
unit. Use a 5/8″ (16 mm) open-end wrench to make
leveling adjustments once the unit is placed in final
position.
4″ Leg
Adjustable Tip
Foot
Stud
Rubber
Foot
NOTICE
CAUTION
WARNING
5. Slide each side glass panel into the upper channel, then
lower the panel into the lower channel.
Figure 10. Side Glass panel Installation (GRpWS-XXXXD shown)
6. Install a box stop with sign holder on the customer side of
each shelf.
• Insert the tabs on the back of the box stop into the
brackets on the customer side of the shelf.
Figure 11. Box Stop w/Sign Holder Installation (GRpWS-XXXXT shown)
NOTE: Unit must be transported in the upright position.
7. place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods
and air conditioning ducts).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• make sure all the feet/legs on the bottom of the unit are
positioned securely on the countertop.
Rear view of
Box Stop
w/Sign Holder
Side
Glass
Panel
Upper Channel
Lower Channel
