Form No. GRCMWHIM-0907
8
MAINTENANCE
Removing and Installing Back Mirror Glass Panel
Back mirror glass panel is removable for cleaning.
1. Carefully lift and slide the mirror panel up out of
the rear brackets on the warmer.
2. Clean mirror.
3. Carefully guide and lower the mirror glass panel
into the rear brackets. (See Figure 5.)
Removing and Installing Side Glass Panels
Side glass panels are removable for cleaning.
1. Lift side glass panel up and tilt outward from the
bottom bracket.
2. Slide glass panel out away from unit.
3. Clean glass.
4. To install repeat steps 1-2 in reverse order. (See
Figure 6.)
Removing and Installing Pan Skirt
1. Lift pan skirt up off of base pins and remove from
warmer.
2. Clean shelf area and pan skirt.
3. To re-install, position the two holes on the pan
skirt over the base pins located at the rear, inside
of the unit. (See Figure 7.)
Removing and Installing Breath Protector
1. Remove four (4) thumbscrews and washers from
top of unit.
2. Clean breath protector.
3. To re-install the breath protector, position it on
top of unit, matching holes in breath protector to
the holes in the standoffs on top of the unit. (See
Figure 8.)
4. Place a washer (previously removed) in each
breath protector hole.
5. Secure with thumbscrews - Do not over tighten.
CLEANING
The Hatco Glo-Ray
®
Merchandising Warmer is
designed for maximum durability and performance,
with minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF
on the unit and unplug the unit from the power
source and allow to cool completely before
performing any maintenance or cleaning.
WARNING
Unit is not waterproof. DO NOT submerge in
water. Do not operate if unit has been
submerged in water to avoid injury.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
CAUTION
To avoid any injury or damage to the unit, do not
move or relocate the unit for cleaning.
To preserve the finish of the Glo-Ray Merchandising
Warmer, the following is recommended:
• Metal surfaces to be wiped daily with a damp
cloth. (Stubborn stains may be removed with a
good non abrasive cleaner.)
• Hard to reach areas should be cleaned with a
small brush and mild soap.
• The glass side and rear panels should be
cleaned with ordinary glass cleaner and a damp
soft cloth or paper towel.
• The polycarbonate breath protector should be
cleaned with a mild, soapy water solution and a
damp, soft cloth. Do not use paper towel.
NOTICE
DO NOT use paper towel or glass cleaner to
clean polycarbonate breath protector. Paper
towel and glass cleaner may scratch the
material. Wipe off breath protector using a soft,
clean and damp cloth.
NOTICE
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit,
marring its appearance and making it
susceptible to dirt accumulation.
