IMPORTANT SAFETY INFORMATION
Form No. FS2HACM-0608
1
FIRE HAZARD: Locate the unit a minimum of 1″
(25 mm) from combustible walls and materials.
If
safe
distances
are
not
maintained,
discoloration or combustion could occur.
This unit has no “user-serviceable” parts. If
service is required on this unit, contact an
Authorized Hatco Service Agent or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
BURN HAZARD: Some exterior surfaces on the
unit will get hot. Use caution when touching
these areas.
Locate the unit at the proper counter height in
an area that is convenient for use. The location
should be level to prevent the unit or its
contents from falling accidentally and strong
enough to support the weight of the unit and its
contents.
The National Sanitation Foundation (NSF)
requires that units over 36″ (914 mm) in length
or weighing more than 80 lbs. (36 kg) either be
sealed to or raised above the installation
surface. If this unit cannot be sealed at the point
of use, 4″ (102 mm) legs are included to allow
for proper cleaning access below the unit.
Use non-abrasive cleaners only. Abrasive
cleaners could scratch the finish of your unit,
marring
its
appearance
and
making
it
susceptible to soil accumulation.
Do not lay unit on the side with the control panel
or damage to the unit could occur.
WARNING
NOTICE
CAUTION
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical
outlet of the correct voltage, size, and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine and install the proper voltage and
size electrical outlet.
• Units supplied without an electrical plug
require field installation of the proper plug.
Plug must be properly grounded and of the
correct voltage, size, and configuration for
the electrical specifications of the unit.
Contact a qualified electrician to determine
and install the proper electrical plug.
• Turn the power switch OFF, unplug the power
cord, and allow the unit to cool before
performing any maintenance or cleaning.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if unit
has been submerged or saturated with water.
• Unit is not weatherproof. Locate the unit
indoors where the ambient air temperature is
a minimum of 70°F (21°C).
• This unit is not “jet-proof” construction. Do
not use jet-clean spray to clean this unit.
• Do not steam clean or use excessive water
on the unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or
worn.
• Do not attempt to repair or replace a
damaged power cord. The cord must be
replaced by Hatco, an Authorized Hatco
Service Agent, or a person with similar
qualifications.
• Use only Genuine Hatco Replacement Parts
when service is required. Failure to use
Genuine Hatco Replacement Parts may
subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco
Replacement Parts are specified to operate
safely in the environments in which they are
used.
Some
aftermarket
or
generic
replacement
parts
do
not
have
the
characteristics that will allow them to operate
safely in Hatco equipment.
WARNING
Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
