INSTALLATION
General
Use the following procedures to operate a Convected Drawer
Warmer.
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
1. Plug the unit into an electrical receptacle of the correct
voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
2. Move the Power ON/OFF (I/O) switch to the ON (I)
position. The switch will illuminate.
• The digital temperature controller will energize and the
current temperature of the unit will appear on the display.
• The phrase “out 1” will appear in the upper left corner of
the display to show that the unit is in heat mode.
BURN hAzARD:
• Some exterior surfaces on the unit will get hot. Use
caution when touching these areas.
• Use caution when opening drawer. hot air escapes
when drawer is open.
WARNING
CAUTION
3. Press and release the
key on the digital temperature
controller to verify the setpoint temperature.
• The setpoint temperature will be shown for 15 seconds.
after 15 seconds, the display will revert to the current
temperature of the unit. To change the setpoint
temperature, refer to “Changing the Setpoint
Temperature” in this section.
Digital Temperature Controller
NOTE: The digital temperature controller is pre-set to a setpoint
temperature of 91°C (195°F) at the factory. Once the
setpoint temperature is changed, the new setpoint
temperature will remain in memory until it is changed
again. The maximum setpoint temperature is 91°C
(195°F).
4. allow the unit 15–20 minutes to reach operating
temperature before loading preheated food product.
Down Arrow
Key
Up Arrow
Key
“out 1”
Celsius
Symbol
SET
Key
6
Form No. CDWCEM-0412
Installing Casters
Use the following procedure to install casters onto the bottom of
the unit.
Do not lay unit on the front or back side or damage to the
unit could occur.
1. Remove any pans from the drawers of the unit.
2. Carefully lay the unit on its left or right side (requires two
people).
3. align the four holes on the caster plate with the four holes
in the bottom of the unit at one corner of the unit.
4. Install a bolt through each of the holes in the caster plate
and into the bottom of the unit. Tighten securely.
NOTICE
Digital Temperature Controller
POWER ON/OFF Switch
Model CDW-3N Control Panel
Caster Installation
5. Repeat steps 3 and 4 for the remaining three casters.
6. Return the unit to the upright position (requires two
people).
Caster Plate
Mounting
Bracket
Bolt
OPERATION