HARVEY HPS1600E, Original Instructions Manual

Page: 30 / 62

- 29 -
d. If the blade is not at 90 degrees
，
loosen screw (C), and turn 90
°
stop (D) in or out, The 90
°
stop (D) should against the block E, when the blade is at 90 degrees to the table. Retighten
screw (C). see
Fig.38
e. If the 45 degree positive stop is not set properly, turn the same hand wheel clockwise as
far as it will go , loosen screw (A), and turn 45
°
stop (B) in or out, The 45
°
stop blot (B)should
against the block E, when the blade is at 45 degrees to the table. Retighten screw (A
).
see
Fig.38
6.5 Crosscut fence
Square to main blade:
The crosscut fence/miter fence must be set 90
degree to the blade. Take a 1000x1000mm MDF or
similar material with thickness at least 15mm, Make 5
cuts. (Put the last cut side against the fence for the
next cut, keep turn the test piece in same direction).
Measure the 5th cut off strip at both ends. The
difference will be less than 0.75mm, see
Fig.39
F ig.39
Adjust as follow
：
a. Release knob E
，
F
，
G and nut A
，
thread screw B in or out, see
F ig.40
b. Make block (C) touch the blot (B)
，
lock nut (A)and lock knob(E),(F),(G).
c. Base the experimentation above to make sure the fence is Square to main blade, till
measure up
。
d. There is two position holes on the crosscut table (
Fig.40)
, at two position, the same
adjustment action must be used.
F ig.40