Maintenance
38
DISCONNECT THE MACHINE FROM THE
MAINS SUPPLY BEFORE CONTINUING!
After a period of time if you notice the blade stopping in mid
cut and the motor still spinning, the V- belt will need tension-
ing. Lower the blade completely and tilt the assembly over to
45˚ degrees to get better access ,see fig 01-02. Open the motor
access door and loosen the Hex screw (A) holding the motor in
place, see fig 04.
Loosen the tension bolt locking nut (B) and adjust the bolt to
increase or decrease the tension on the V-belt. Tighten the
locking nut (B) against the casting to lock the setting and
nip-up the Hex screw (A) to secure the motor. The V-belt is
correctly tensioned when there is appoximately 1/2" defection
as it’s pushed with moderate pressure, see illustration below.
Close the motor access door. Connect the saw to the mains,
switch on and run a piece of timber through. If all OK, switch off
& disconnect the machine from the mains.
Belt Tension
Changing the V-Belt
Lubrication
3
1
5
6
4
2
A
B
Tensioning
bolt
If you notice fraying, missing teeth or damage to the V-belt, the
belt will need to be replaced. As it is difficult to remove, contact
our customer service department to arrange for your machine
to be serviced by one of our trained service engineers.
Phone: 0800 371822
Email: [email protected]
[email protected]
After every three or four months
we recommend you lubricate the
blade and the tilt, rise and fall screw
threads using ‘Ambersil Dry PTFE
Film Antistick’ spray.
Code: 952137
Summary of Contents for Axminster AT254LTS
