HARVEY Axminster AT254LTS, Original Instructions Manual

Page: 27 / 56

Optional Accesories Assembly
27 27
DISCONNECT THE MACHINE FROM THE
MAINS SUPPLY BEFORE CONTINUING!
Code 104504 Shark S-12 Overhead Crown Guard
The Shark S-12 Overhead Crown Guard is for the AT254TS or
AT254LTS Table Saw. This style of crown guard offers a higher
level of user safety and a more efficient dust collection.
The heavy duty steel frame, cast joints and high grade alloys
make it rigid yet easy to adjust. The large, unbreakable polycar-
bonate hood gives great visibility for safer use. The hood
assembly can be set at any height above the blade through a
linear guideway and supporting air strut. When you need to
change the blade the whole top arm hinges back to the rear.
A must when using a dado cutter head, the crown guard will
enhance this table saw, making your work safer and more
efficient.
1
2
3
4
3. Screw on the threaded foot unit into the leg, then mount
the leg to the support arm by two cap screws M10x25mm,
see diagram 3.
4. Install the support arm to the heavy duty rear rail by three
Hex bolts M12x110mm, see diagram 4.
1. Remove the standard rear rail mounting plate (A) and the
rear extension table (B). Locate the heavy duty rear rail, see
diagram 1. Secure the heavy duty rail in place and replace the
rear extension table assembly (B). Refer to ‘Assembly/Setup and
adjust both extension tables and rip-fence until correct.
B
A
Heavy duty rear rail mounting plate
TWO PERSON
ASSEMBLY!
Continues over...
Height locking nuts