8
Baler Monitor Setup
At any time after
the initial Start Up/Power On the green “uploading data status bar (arrow A) may begin to fill.
However, due to software version changes a status does not appear on all monitors. To begin setup of the
77E Microwave System select the fourth icon down on the right screen menu-the wrench icon (arrow B).
The service screen displayed below will appear. Here you can see the Version of Software for your baler which
should be 3.30 or higher to enable working with the 77E. Select the icon (arrow C) located at the bottom of the
right selection menu to move to the next options menu.
Then select the
‘A B’ icon (arrow D) on the right side, this should be the top button.
C
B
A
D
