11
Wiring Diagram
1. Locate the tractor power/communication harness (006-6650TM(E)).
2. At the back of the tractor run the power leads to the battery.
3. Connect the red power wire with the 50 amp fuse to the positive side (12 volt) of the battery.
a. The power harness must be connected to the battery!
The unit will draw more amps than
convenience outlets can handle. Any modifications of the power harness will void systems warranty.
b. This unit will not function on positive ground tractors.
4. Connect the black ground wire to frame of tractor or negative side of (12 volt) battery.
5. Connect the Bluetooth Receiver (030-6672A) to the Communication Harness (006-6650TM). Place in a
safe location in the cab. Behind the seat for example.
6. Connect the orange Keyed Power wire (006-5650K) to a keyed power source.
7. Connect the end to the Communication Harness (006-6650TM(E)) to the Bluetooth Receiver.
8. Connect the orange keyed power wire (006-5650K) to a keyed power source on the tractor.
9. Connect the Chute Wire Harness (006-6650MWL) into the Pump Controller port on the DCP.
10. Connect Microwave Sensors (006-4641MTX & 006-4641MRX) to the Chute Wire Harness.
11. Connect the Stuffer Sensor (006-7400) to the Chute Wire Harness.
12. When running a steamer, connect the Power / Comm extension harness (006-6650FMX) to the baler
mounted Power / Comm Harness (006-6650LS2(E))
an additional 25’ length from the tractor to the baler.
Keyed Power Extension
006-5650K
Dual Channel
Processor (DCP)
006-6671LS
Moisture/Bale Rate Harness
006-7303H(E)
Proximity Sensor (2X)
006-7303S
Star Wheel
Assembly (2X)
006-4641
End of Bale Sensor
006-7400
Optional Port
Active Terminator
from Baler Harness
Baler Interface Harness
006-6650VA
Orange Wire to
Keyed Power
Power/Comm Harness on Baler
006-6650LS2(E)
Power/Comm Harness on Tractor
006-6650TM(E)
Data
Transfer
Baler
Connection
Bluetooth Receiver
030-6672A
Stuffer Sensor
006-7400
Microwave TX Sensor
006-4641MTX
Microwave RX Sensor
006-4641MRX
Chute Wire Harness
006-6650MWL
AGCO 2100 Series Balers Pre 2012 need the AGCO Integration Harness (006-6650VAX)
*Note: (E) indication is used
for International Dealers
Summary of Contents for 602A
Page 22: ...22 Notes...
