9
601A - Wiring Diagram
– Connecting to Moisture Only System
1. Locate the tractor power/communication harness (006-6650TM(E)).
2. At the back of the tractor run the power leads to the battery.
3. Connect the red power wire with the 50 amp fuse to the positive side (12 volt) of the battery.
a. The power harness must be connected to the battery!
The unit will draw more amps than
convenience outlets can handle. Any modifications of the power harness will void systems warranty.
IF MODIFICATIONS ARE REQUIRED CONTACT HARVEST TEC FIRST!
b. This unit will not function on positive ground tractors.
c. If the unit loses power while operating it will not keep track of accumulated pounds of
product used and bale records.
4. Connect the black ground wire to frame of tractor or negative side of (12 volt) battery.
5. Connect the Bluetooth Receiver (030-6672B) to the Communication Harness (006-6650TM). Place in a
safe location in the cab. Behind the seat for example.
6. Connect the orange Keyed Power wire (006-5650K) to a keyed power source.
7. Connect the end to the Communication Harness (006-6650TM(E)) to the Bluetooth Receiver.
8. Connect the orange keyed power wire (006-5650K) to a keyed power source on the tractor.
9. Connect the Pre-Compression Harness (006-6650MW) into the Pump Controller port on the DCP.
10. Connect Microwave Sensors (006-4641MTX & 006-4641MRX) to the Pre-Compression Harness.
11. Connect the Stuffer Sensor (006-7400) to the Pre-Compression Harness.
Keyed Power Extension
006-5650K
Dual Channel
Processor (DCP)
006-6671LS
Moisture/Bale Rate
Harness
006-7303H(E)
Proximity Sensor (2X)
006-7303S
Star Wheel
Assembly (2X)
006-4641
End of Bale Sensor
006-7400
Optional Port
Active Terminator
from Baler Harness
Baler Interface Harness
006-6650VA
Orange Wire to
Keyed Power
Power/Comm Harness on Baler
006-6650LS2(E)
Power/Comm Harness on Tractor
006-6650TM(E)
Data
Transfer
Baler
Connection
Bluetooth Receiver
030-6672B
Stuffer Sensor
006-7400
Microwave TX Sensor
006-4641MTX
Microwave RX Sensor
006-4641MRX
Pre-Compression Harness
006-6650MW
AGCO 2100 Series Balers Pre 2012 need the AGCO Integration Harness (006-6650VAX)
*Note: (E) indication is used
for International Dealers
