9
Dye Marker Installation
– 200DM (Optional)
Locate the dye marking kit tank and pump assembly (005-9015). Identify a
suitable mounting location for the tank away from moving parts and hydraulic
li
nes on the baler. Be sure to mount the tank within 10’ of the connection on the
Baler Pwr/Comm Harness (006-2470SS), wiring details in the wiring diagram.
Note:
The mounting location will potentially be different for the tank on each
baler model. Due to various baler designs and modifications, Harvest Tec does
not offer a specific mounting location for each baler model.
Once a mounting location has been identified, mount the tank vertically as
shown (right) with the tank lid on the top using the included hardware.
Next locate the dye marking spray assemblies shown (below).
*Small square and Large square balers must us the brass tip (004-TX-5)
Nozzle straps should be placed directly below the star wheels so spray will be applied on the side of the bale.
Mount the second tip assembly on the left side of the baler in a similar position (below).
Alternative Dye Marking Nozzle Mounting Location
When using the alternative star wheel mounting location at the end
of the bale chamber, the dye marking nozzles can be located at the
rear of the bale chamber as shown (left).
Routing the Hose
Using the supplied 1/4” hose (002-9006) connect to the pump and
secure with the hose clamps (003-9002). Route the hose to each tip
assembly by using the 1/4" barbed tee (003-T1414) to go to each
side of the baler. Be sure to avoid moving parts.
