6
Installation of Star Wheels
(continued)
John Deere L330-L341 Balers
Remove any material from the bale chute. The star wheels are to
be mounted on the transition bracket on both sides of the bale
chute located after knotters shown above. Holes have been
installed at the factory, however you need to remove bracket and
cut 3/4” (19mm) off the bracket as indicated below to allow proper
spacing for star wheel assembly.
Once complete, touch up with spray paint to prevent rusting and
place the carriage bolts that mount the transition bracket back in
original bracket mounting holes (A) before mounting star wheel
assembly
(C).
Insert the 5/16” x 3 1/4” Allen head bolts up
through the transition bracket and use nuts to hold the bolts in
place (B). Place the star wheel block over the nuts. Place twine
guard on top of star wheel (D), the guard containing bale rate
sensors will be placed on the right side.
Note: Thicker part of star wheel block should be on baler side.
Transition Bracket Location
A
B
D
C
Cut
3/4” Off Bracket
Star wheel assembly
