10
Wiring Diagram
1. Connect the power harness (006-2470P) to the tractor convenience outlet keyed power switch using the
red wire with fuse to the positive side and the black wire to the negative.
a. Any modifications of the power harness will void the warranty. Contact Harvest Tec before
modifications are made.
2. The power harness (006-2470P) will mount on the tractor connected to the control box (006-2473SB) with
the 12 pin male deutsch connection and the opposite end down to the draw bar.
3. Connect the Baler Pwr/Comm Harness (006-2470SB) to the power harness (006-2470P).
4. Route the Pwr/Comm Harness (006-2470LS) on the baler to each moisture sensor on both sides of bale
chamber, sensors are pn 030-4641.
5. Connect the USB charging/comm cord for the phone or tablet being used, to that device and the 201
control box (006-2473SB).
6. When using a Dye Marker the End of Bale Sensor kit will need to be added to the system in order to see
when needle arm cycles. Part number (200FCA). Connect the sensor to the End of Bale (EOB) connection
on the Baler Pwr/Comm Harness (006-2470LS).
7. When using the optional Dye Marker (200DM) connect 4 pin round end of the H2O harness (006-2470C) to
the Dye Marker (DM) connection on the (006-2470LS) harness. Then connect the two straight spade
connections with only the white wire to the push switch (006-2850). The remaining two connections with 90
degree female spades will connect to the pump.
System wiring diagram
Power Terminals
(Connect to keyed
power source)
201 Control Box
006-2473SB
Baler Pwr/Comm Harness
006-2470LS
End of Bale Sensor
006-7400
(Complete Kit 200FCA)
Moisture Star Wheel
030-4641
*If needed an optional 8’ Pwr/Comm harness extension is available (not included), part number 006-2470BL.
*Required when using Dye Marker
Dye Marker
(200DM)
H2O Harness (10’)
006-2470C
H
2
O Wired Power Harness
006-2470P
Phone or Tablet
(not included)
Phone or Tablet USB
charging/comm cable
(not included)
