Rev.: 2016-09-19
6 / 6
Owner’s Manual Crimping Tool HARTING Han-Fast® Lock
8. Warranty
The crimp system tool is subjected to a thorough quality control process.
General warranty conditions apply.
9. Maintenance and Service
Before starting work, ensure that the crimping tool is clean and in proper working condition.
Crimping residue must be removed. Joints should be oiled regularly with a light mineral oil and must be
protected against dirt. All bolts need to be secured with retaining rings. Check if the setting dial is secured
tightly by the slotted headless screw.
Any repairs of the crimping tool must be performed by the manufacturer or an authorized workshop.
1. Use a screwdriver to remove the slotted headless screw
1
.
2. If the setting dial (
2
) is rotated counter-clockwise (+), a higher crimp force and a
smaller crimp height will be reached.
3. If the setting dial is rotated clockwise (-), the crimp force is reduced and the crimp
height will increase. The newly adjusted crimp force should not exceed 180 N.
4. If bolt aperture
3
is used, the crimp force can be adjusted by only half a notch. A
fine adjustment is hereby possible.
5. Place the slotted headless screw back onto the pliers
6. Prior to using the tool, ensure that the setting dial is properly secured with the
slotted headless screw.
1
2
The crimping height should be monitored by qualified personnel of the quality control
department periodically and should be adjusted by using the following steps:
Attention
3