HART VOC812SW 3701, Operator'S Manual

Page: 6 / 50

6
ATTACHING THE REAR WHEELS & CASTERS
See Figures 7 and 8.
•
Turn the collection tank upside down. Insert the two caster
feet into the slots on the front of the collection tank and
tighten with supplied screws. The rear wheels and the
vacuum base are marked with the numbers 1 and 2. Insert
wheel 1 into slot 1 on the back of the vacuum and tighten
with supplied screw. Insert wheel 2 into slot 2 on the back
of the vacuum and tighten with supplied screw. Verify
that the rear wheels and casters are mounted correctly
as shown. Do not over-tighten screws.
ATTACHING THE HANDLE
See Figure 9.
•
Attach the handle into the slots located on the top of the
power head and secure with supplied screws.
INSTALLING THE PULL/PUSH HANDLE
See Figure 10.
•
Insert the pull/push handle into the handle sockets
mounted on the sides of the collection tank. Push down
until the lock pins click into place.
INSTALLING THE CARTRIDGE FILTER
See Figures 11 and 12.
•
Your vacuum comes ready for dry vacuum cleaning. If
the cartridge filter is not installed, refer to page 13 for
installation instructions.
INSTALLING THE DUST COLLECTION BAG
See Figure 13.
•
Optional: For improved dust filtration, fit the dust bag
flange onto the inlet port, taking care not to damage the
bag.
ASSEMBLY
FIG. 7
FIG. 8
FIG. 9
FIG.10
FIG.11
FIG.12
FIG.13
REAR WHEEL
CASTER
DUST BAG
CARTRIDGE
FILTER
PULL/PUSH
HANDLE