HART VOC812SW 3701, Operator'S Manual

Page: 7 / 50

7
INSTALLING THE FOAM WET FILTER
See Figure 14.
•
For wet vacuum cleaning, remove the cartridge filter, and
install the supplied foam wet filter. See page 13 for the
foam wet filter installation instructions.
ATTACHING THE POWER HEAD
See Figure 15.
•
Place the power head back on the collection tank aligning
the top section with the latches, and snap into place.
ATTACHING THE HOSE
See Figure 16.
•
Insert the locking end of the hose into the vacuum port
on the collection tank and lock into place.
ASSEMBLY
FIG.14
FIG.15
FIG.16
HOSE
POWER HEAD
INSTALLING & REMOVING ATTACHMENTS
See Figures 17 and 18.
•
These attachments lock together to prevent them from
detaching during use. Connect the desired attachment
onto the end of the hose or extension wand by aligning
the tabs and push together until they lock into place.
•
To remove the attachment, press down on the locking tab
and slide it off.
FOAM WET
FILTER
FIG.17
FIG.18
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a
polarized plug (one blade wider than the other). This plug
will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do
not change the plug in any way. Double insulation
eliminates the need for the three wire grounded power cord
and grounded power supply system.