25
(c) Fully remove one screw from the taper
lock, and having oiled it, insert into the
threaded jacking point.
(d) Tighten screw until the taperlock is free.
(e) Remove taperlock and pulley.
(f) Fit taperlock in new pulley, and
provisionally position on the shaft.
(g) Remove the screw from the jacking
point, and tighten both screws in their
clamping points until the pulley can just be
moved on the shaft by hand.
(h) Align pulleys using a straight edge, and
by gradual alternate tightening of the screws
clamp in position.
(i) Refit belts and check for the correct
amount of tension.
Fan Belts
Check belts for signs of wear. Frayed or split
belts must be replaced
using belts with a
common batch code.
Belt tension must be
checked, and if on multi-belt units it is found
that one belt contains more slack than its
accompanying belts, then all the belts on the
unit must be replaced, again using a
common batch code. Replacement and
tensioning is carried out as follows.
Note
The maximum displacement at the mid point
of the top edge of the belt must not be
greater than 16mm per metre of span, when
a force of 3kg is applied in a plane
perpendicular to the belt.
(a) Loosen fan motor securing bolts on
chassis.
(b) Loosen fan motor slide adjustment bolt.
(c) Slide motor towards fan to slacken belts.
(d) Replace belts, pull fan motor away from
fan until belts are tight.
(e) Tighten adjustment bolt to hold motor.
(f) Tighten fan securing bolts ensuring that
the fan is square and the pulleys aligned.
(g) Check belt tension, making final
adjustments as necessary.
(h) Tighten and clamp fasteners to hold fan
motor in position.
Automatic Controls
Automatic control is by way of a Honeywell
controller.
Spark Ignition is via an ignition electrode
Ensure that the ceramic insulation material
is not damaged or cracked.
Flame supervision is via a flame sensor rod.
Check the flame sensor rod for signs of
pitting or corrosion, ensure that the ceramic
insulation material is not damaged or
cracked. Check connections are secure.
Main Governor
To adjust the main governor, using a
screwdriver remove the metal cover to
reveal the adjustment screw, and turn as
follows :
Clockwise to increase pressure.
Anticlockwise to decrease pressure.
It should be noted that full clockwise
adjustment will result in the valve being
closed permanently.
Gas Supply
The gas supply pipe work and fittings should
be inspected to ensure they are free from
corrosion and that where brackets have
been fitted these remain secure and offer
adequate support. The system should be
soundness tested in accordance with
Institute of Gas Engineers recommendations
detailed in Utilization Procedures IGE/ UP-1
and 2
Test
Test and re-commission as per sections 3.0
to 3.4 inclusive
Report
A full and detailed service report should be
prepared, it is advised that the report is not
completed until the heater has been re-
commissioned, where upon the completed
report can then be run through with the user.
This must be regarded as a necessary part
of the heater service by the servicing
engineer.
Summary of Contents for HT2000
Page 51: ...51 Notes...