Harper TURBO VAC 60R, Operator'S Manual

Page: 13 / 64

R
R
Turbo Vac TV60R
Replacement Parts
SAFETY WARNING!
Use genuine factory parts or parts with
equivalent characteristics including: type,
strength and material. Failure to do so
may result in voidance of warranty,
product malfunction or possible injury to
operator and others.
• Replace locknuts and locking screws if
they can be tightened without
considerable resistance for several
turns before they are completely tight.
• If hardware is not secure, or if some of
the fasteners are over-tightened,
equipment failure may result, posing
possible safety hazards.
• Use proper torque specifications for all
fasteners when they are replaced.
Gasoline
SAFETY WARNING!
Gasoline is extremely flammable and can
be highly explosive.
• Always use an approved container for
gasoline.
• Do not allow open flames or sparks
while performing maintenance or refu-
eling.
• Never remove the fuel tank cap or add
gasoline when the engine is running or
while it is hot.
• Never fill the fuel tank indoors. Gaso-
line fumes are heavy and will sink to the
lowest point, collecting and becoming
increasingly hazardous. One part
gasoline in 20 parts air will explode
easily and violently.
• Wipe up spilled gasoline immediately.
• Do not store gasoline in a room with an
appliance that has a gas pilot or elec-
trical switch that may cause sparks.
• Always store gasoline outside in a
safety can (a can that has a flame
arrestor and pressure relief valve in
pour spout).
• Never store the equipment with gaso-
line in the tank inside a building where
fumes may reach an open flame or
spark.
• Allow the engine to cool before storing
in any enclosure.
• Be certain to provide adequate ventila-
tion if an engine must be run indoors -
exhaust fumes are dangerous.
Hydraulics
SAFETY WARNING!
HIGH-PRESSURE FLUID HAZARD!
Escaping fluid under pressure can
penetrate skin and cause serious injury
or death.
To prevent serious injury or death:
• Relieve pressure on system before
repairing, adjusting or disconnecting.
• Wear proper hand and eye protection
when searching for leaks.
• Use wood or cardboard instead of
hands when looking for leaks.
• Keep all hoses, fittings and compo-
nents in good repair.
• Do not use any type of heat or flame
(welding, soldering, cutting torch, etc.)
near pressurized hydraulic lines.
11