Harper DewEze S3, Operator'S & Parts Manual

Page: 8 / 45

S3
Set-Up Instructions
S3 Load Arm Assembly
• Remove Load arm from inside of table,
and lay on ground
• Align load arm bolt flanges with table
flanges
• Bolt the load arm flanges on the back
side of the table flanges, with the (9)
bolts, flat & lock washers that are
provided. (Refer to Image Below)
Connect Load Cylinder to Load Arm
• Connect loading fork through loading
fork frame arm flanges
• Insert washers as necessary so cotter
pin sits flush (Refer to Images Below)
• Grease Lubrication Points on lower
fork (3 Grease Zerks)
Install Outside Fork
• Raise load arm up enough to slide the
outer sleeve of the fork over the load
arm, slide down to align the pin to go
in place, and insert cotter pin.
• Raise load arm to upright position, and
hook safety chain in place.
Install Kicker Arm
• Install the Kicker Arm by pinning in
place, ensuring that the curved side
is facing down so that it can rest on
the load arm slides, and insert cotter
pins.
*Kicker Arm can only be installed if the
table has been shifted over into fieldposi -
tion.
5. Slide table into feeding position (fig 3)
and secure with bolts. The feeding
position is marked on the underside of
the table with bolt hole slots. The slots
are located on the trailer on the angle
iron rails the table is sitting on. They
are shown in figures 4 & 5 on next
page.
6 7