INSTALLATION INSTRUCTIONS SURFACE-MOUNTED SCREEN SC900 - SC910
03/15
|
3
1. INTRODUCTION
The
SC900
screen is a flat hanging sun screen, which is fitted on top of the window with
a 'zipper system' on each side of the fabric. This makes the screen particularly resistant to high
winds and keeps the fabric perfectly in place. In the down position the screen keeps out the
sun's rays, which can cause overheating, while at the same time it gives a view to the outside.
Moreover, this screen offers practical protection against insects, as the space between the
box, the guide rails and the fabric is completely sealed off.
The SC900 can also be fitted with fabrics that are almost fully opaque, making it especially
suitable to black out presentation rooms in office buildings, laboratories, hospitals etc.
The installation of this sun protection system is explained step by step in these instructions.
The
SC910
screen is a flat hanging sun screen with the same properties, but without the
insulation and cover (for the box). It is basically a 'naked' version of the SC900 screen.
Attention!
Open box, standard version without the back covered. This version requires a suitable
finish to avoid damage to and prevent dirt from settling on the fabric. (possible option =
full support plate instead of brackets)
2. GENERAL WARNINGS
A number of precautions have to be taken for the safe installation, operation and maintenance
of this screen. Please take notice of the following warnings for the safety of everyone concerned!
!
These instructions have been drawn up for use by trained installers and therefore are
not suitable for use by amateurs or trainees.
!
Please read these instructions carefully before starting the installation.
!
Proceed carefully. Ensure that you have a robust footing.
!
Make sure there is adequate lighting in the place of assembly. Remove any obstacles
and dirt. Ensure that no other persons other than the installers are present.
Unauthorised persons can get in the way or be at risk during the installation.
!
The screen must be kept clearly in view at all times during installation and operation.
Persons in the vicinity may be at risk of injury.
!
The installer must comply with the local regulations and standards with regards to
electrical connections.
!
Our products must be installed in such a way that all parts remain accessible at all times
for maintenance and repairs. If this is not the case, Harol cannot be held responsible for
any additional costs (e.g. demolition work, repairs to exterior or interior walls) which may
result from this.
