Harol OB450, Assembly Instructions Manual

Page: 3 / 8

- 3 - V1-05-06
Assembly instructions built-on shutter OB450
D. Fitting
Fitting the OB450 on the window frame
• Remove the protective film of the roller shutter box and
unwrap the guide rails.
• Use some tape to keep the curtain inside the box.
• At the bottom side of the OB450-box there is an adhesive
strip. Take off the protective film of this strip (zie fig 2).
• The standard frame brackets must be fastened to the heads
of the box by using screws (fig3). These frame brackets will
be used later to fix the shutter to the window frame.
• If you ordered the shutter-box without holes for the operation passages, they have to be provided
now, before starting the actual fitting of the system.
• The built-on shutter system implicates that the shutter box and the shutter guide rails are fitted on
the window frame, before the window itself is fitted into the opening (fig 9). Make sure the upper
side of the window frame is free of dust and fat. Put the shutter box on the window and press. Fasten
by screwing sideways. (fig 4) fig 4
• Fasten the clips of
the guide rails to the window frame (every 30 cm) (fig 5).
• The guide rails are fastened to the window frame by clipsing them onto the pre-mounted clips.
Figure 1
Figure 2 Figure 3
Figure 4