20
The use of the chlorinator
1.
When the chlorinator is connected to the faucet, adjust the water flow with the
valve to ensure there is enough water through the salt chlorinator.
2.
To connect the power cord, open the decorative cover of the chlorinator in the
direction indicated by the arrow on the cover. Insert the round plug into the power
adapter (as shown in Figure 3), then replace the decorative cover to its original
position.
3.
Make sure the salt concentration of the pool water is within the normal operating
range, otherwise it may shorten the life of the Titanium cell.
4.
Close the loss current unit switch to activate the display. The display will show the
current water temperature. Press the Power / Operate button, the operating light
will change from red to green and the chlorinator will start working: Note: the
chlorinator can only operate if the water level detector detects the presence of
sufficient water flow.
5.
When connecting the pipes, use only line suitable for gluing PVC
6.
By pressing the "+" or "-" button, users can adjust the chlorine concentration level
as needed; users can use level 1-5, 1 level is the smallest and 5 level is the highest.
The higher the level, the higher the concentration of chlorine is produced.
7.
Parameter control: press the acceleration button several times while the
chlorinator is turned off to look up different parameters below:
1
Internal temperature chlorinator
2
Water temperature
3
Input voltage
4
Version number
5
Time period of continuous operation; the system leaves the application
automatically after 3 seconds
8. Time setting for continuous operation: Press the acceleration button 5 times while the
machine is switched off to display the time period of continuous operation. Change the
time periods of continuous operation by pressing "+" or "-". The time period will vary from
1-24 hours (and then turn off) after it is turned on. After this cycle, the chlorine system
stops for 12 hours and turns on again for 12 hours.
IMPORTANT
: THE CHLORINATOR IS PRESET FOR CONTINUOUS OPERATION FOR 12
HOURS; IF 24 HOURS OF NON-STOP OPERATION IS REQUIRED, THE TIME FOR
CONTINUOUS OPERATION SHOULD BE SET TO 24; THE SYSTEM AUTOMATICALLY EXITS
THE SETTING AFTER 3 SECONDS.
Summary of Contents for Hydrolyse EC12
Page 1: ......
