8
STEP 10
(Installing Headboard-Option)
STEP 9
Raise the Backrest by using Remote Control (A).
Take out the Hex Key (K),Wrench (J), 8x Bolts (L), 8x Nuts (N) and 16x Washers (M) from the accessories box.
Refer to the following picture, place the Headboard Bracket (I-1) on the tube of the right hand side of your
Adjustable Base.
Insert the Bolt (L) with the Washer (M) through the pre-drilled holes on the Bracket (I-1) and the vertical
tube
on your Adjustable Base.
Fasten the Bolt (L) with the Washer (M) and the Nut (N) by using the Wrench (J) and Hex Key (K).
The Bracket (I-2) allows adjustment to meet the dimension of user
's Headboard.
After choosing desired pre-drilled holes on the Bracket (I-2), pass the Bolt (L) with the Washer (M) through
the holes on H-1 and H-2 Brackets.
Fasten these Bolts (L), Washers (M) and Nuts (N) by using the Wrench (J) and Hex Key (K).
Redo these steps on the other side of your Adjustable Base.
L
M
N
M
I-1
I-2
Step 11
Now place your mattress on your Adjustable Base. All the installation procedures have been completed.
8
Take out Retainer*1 (F) and Side Retainers*2 (O). Insert the retainers into the corresponding holes on the
Retainer Bar Fixation at the bedside and the foot of your adjustable base.
Summary of Contents for Folding Adjustable Base
