866-351-2776 | www.Harmar.com |
| Pinnacle HD Stair Lift Manual
9
P/N: 75403 RevB 72618
Installation Procedures
Step 6: Install one of the rack pre-compression screws in the threaded hole in the top
rail plate; tighten as firmly as possible by hand with a 5/32
"
Allen wrench.
There are three (3) kinds of pre-compression screws:
1. 1/2
"
for tracks under 6
'
2. 3/4
"
for tracks between 6’ and 12
'
3. 1
"
for tracks over 12
'
Step 7: Plug in the battery charger at either end of the rail, choosing
the closest or most convenient location of a wall power supply. Minimize
wire length and intrusion.
E. FOOTREST & SEAT INSTALLATION
Step 1: Remove footrest from box and use the installation switch to drive the chassis
downward to a position about 6
"
clear of the floor. This provides a safe area to install
and adjust the footrest. Do not drive the unit into bottom stop.
Step 2: Turn the red “ON/OFF” switch located on the top of the chassis to the
“OFF” position (0).
Step 3: Position the footrest onto the two (2) seat-leveling bolts on the
outside of the chassis by aligning the large opening at the slot ends of the footrest.
Step 4: Ensure the footrest is fully engaged.