866-351-2776 | www.Harmar.com |
| Pinnacle HD Stair Lift Manual
13
P/N: 75403 RevB 72618
Remote Call/Send Control Operation
III. REMOTE CALL/SEND CONTROL OPERATION
A. REMOTE CONTROL OPERATION
The key switch on the arm of the chair must be in the “ON” position to use the
remote call/send control.
STEP 1: Press and hold the appropriate directional button on the front of the hand
control. The LED indicator light will turn green when a signal is being sent.
The chair lift will operate with or without a rider. All safety sensors on the chair lift are designed to continue to
operate in their normal mode. The LED light indicator on the armrest will also display the appropriate color.
STEP 2: If the chair lift fails to respond, this may indicate the batteries are discharged and need to be replaced.
Remove the back cover of the control and replace with commonly-available AAA batteries, ensuring that the
polarity is correct.
B. REMOTE CONTROL RE-PROGRAMMING
All call/send controls are factory programmed. Re-programming is not normally necessary during installation.
In the event that the remote call/send control needs to be re-programmed, it is essential to program BOTH
controls in one programming cycle. Do so by completing the following:
1.
Start with the red “ON/OFF” switch in the “OFF” position (0).
2.
Disconnect the 6-pin footrest and 8-pin chair wire harnesses from the chassis.
3.
Press and hold the install switch (located on the top of the chassis) in either direction.
4.
Turn the red “ON/OFF” switch to the “ON” position (I), and then release the install switch.
5.
The lift will begin to beep rapidly (this means the first remote control is ready to program).
6.
Press and release the “UP” or “DOWN” button of the first remote control (the first remote control is now
programmed).
7.
Press and release the “UP” or “DOWN” button of the second remote control (the second remote control is now
programmed).
8.
Upon completion, two beeps will indicate that both remote controls have been programmed.
9.
Turn the “ON/OFF” switch to the “OFF” position (0).
10.
Connect the 6-pin footrest and 8-pin chair wire harnesses to the chassis and then turn the red “ON/OFF” switch to
the “ON” position (I).
11.
Test each remote control in both the up and down directions.