Pinnacle HD Stair Lift Manual |
| www.Harmar.com | 866-351-2776
8
P/N: 75403 RevB 72618
Installation Procedures
D. FINAL RAIL INSTALLATION
Step 1: Install the remaining plastic rack pieces in the upper rail.
Step 2: Use a hacksaw or chop saw to cut the last plastic rack piece flush with
the rail end. Place something on the floor to catch debris or mark and cut the
rack outside.
The exposed, cut end of the plastic rack should face the top end of the rail
(the factory-cut side should butt against the lower rack).
Step 3: Slide the top limit cam into one of the cam slots (either side), and
tighten the pre-inserted Allen screw with a 5/64
"
Allen wrench. This will
be used to set the final upper limits for the stair lift.
Step 4: Remove charging strip from the rail box. Connect charging strip connector
to the charger wire that runs through the center of the rail from the lower charging strips.
Insert the two (2) charger strips into the keyed slots at the top of the rail (while standing on
the top landing looking down). The charging strip with the red wire should be inserted into
the left slot with the metal strip facing out. The charging strip with the black wire should be
inserted into the right slot with the metal strip pointing out.
Bend the red and black wire tabs in toward the center of the rack.
Insert excess cable into the rail, leaving the pigtail with the Molex connector.
Step 5: Install the end plate to the top of the rack with the four (4) self-cutting Torx
screws using the supplied T30 Torx bit.
TIP!
Too much torque applied to these screws may result in damage.
Take your time and apply grease to threads.