12 |
P a g e
Ramp Run Handrail Assembly
1.
Secure handrails to ramp section with
the 2” carriage bolt, washer, and
1/2”
nut. When possible, install rails with
ramp lying flat on the ground, but this
can also be done on an incline. If bolt
holes do not line up, use an alignment
tool or bar clamp to assist. It may be
necessary to temporarily lower a leg,
secure the rails, and reset the leg.
2.
Before attaching the next section of rail, you must install
the connection sleeve into the upper tube on the handrail.
Slide connection sleeve roughly half way into upper tube
and secure with provided self-tapping screw. The handrail
tubing is already predrilled for this connection. Using a
driver guide while installing the #2
screws is highly recommended for
speed and safety.
3.
With connection sleeve installed, you
can now mount the second handrail.
Slide second handrail into connection
sleeve and then rotate down and
align with bolt holes.
4.
Install second self-tapping screw into the opposite side of each connection
sleeve. Use predrilled hole in upper tube of handrail. Each rail joint should
have one connection sleeve and two screws.
04OCT19 | 630-00103-01 Rev B
