Harmar Mobility Highlander RPL400, Owner'S Manual

Page: 6 / 12

Highlander Manual | | www.harmar.com | (800) 833-0478
6
OPERATION AND SAFETY
OPERATION SAFETY
Press the Up or Down
Direction Button.
The limit switches will
stop the lift platform
level with the upper
landing. At the bottom,
the access ramp unfolds
and rests on the ground.
Emergency Stop.
Press the Emergency Stop
button. This will prevent
the lift from running
in either direction. To
operate the lift normally,
pull the switch back out.
NOTE: The sensor pan
beneath the platform is
designed to stop the lift
when it hits an object
underneath it. You can
verify the operation of the
sensor pan by starting the
lift at the top landing. Press
up on the sensor pan. While
holding the pan in this
location, press the down
switch on the platform. The
lift should not run. Check
all sides and middle of the
safety pan.
IMPORTANT: Read all instructions in this Owner’s Manual before
operating the lift.
CAUTION: Center weight on lift’s platform. Lock brakes before
operating lift when using with a wheelchair or scooter. Do not use
lift if you suspect damage or wear.
• This RPL meets ASME A18.1 safety standards. However, ensure
that you and those servicing this product follow all safety
procedures.
• Do not disable any safety equipment or switches supplied with
this lift.
• Lock wheelchair brakes before operating lift.
• Stay away from all drive train components while the lift is
operating.
• Do not exceed the maximum payload capacity of 600 lbs.
• Do not ride on the lift until it is anchored in place.
• It is recommended that a gate or door be installed at the upper
landing.
• This product is designed only for lifting people and mobility
devices. Do not use for any other purpose.
• Ensure that this lift is always disconnected from the electrical
source before servicing.
• Loose clothing or jewelry should never be worn by a person
working on the lift
• The lift requires a 115VAC 15 AMP grounded, dedicated
electrical outlet within 6 feet of the lift. Plug the lift directly
WARNING: Moving components can cut and crush. Do NOT
operate the lift if you or anyone else is in close proximity to any
drive components. Be aware that loose clothing or jewelry may
catch on moving parts.
WARNING: The area between the floor where the lift is mounted
and the top landing must be covered by a smooth vertical fascia to
eliminate pinch points between the platform and landing.